Due to rapidly growing in IT industry the Cisco 300-115 exam is very important for your professional life. You can pass Cisco 300-115 exam easily with RealExamDumps’s latest 300-115 exam questions. We at RealExamDumps provide you latest Implementing Cisco IP Switched Networks 300-115 exam questions that are going to be asked in the exam. When you will become Implementing Cisco IP Switched Networks 300-115 exam certified then you will exel in Describe chassis virtualization and aggregation technologies and Describe device security using Cisco IOS AAA with TACACS+ and RADIUS. All Cisco 300-115 exam questions prepared by the subject matter experts who are professional in their respective fields.
|Full Exam Name||Implementing Cisco IP Switched Networks|
|Certification Name||Cisco Certified Network Professional Routing and Switching|
♥ 2019 Valid 300-115 Exam Dumps ♥
300-115 exam questions, 300-115 PDF dumps; 300-115 exam dumps:300-115 Exam Dumps (570 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)
Latest and Most Accurate Cisco 300-115 Exam Dumps:
Which two VLAN ranges can you add. modify or delete on a switch’? (Choose two)
A. 1 through 1001
B. 1006 through 4094
C. 1005 through 4094
D. 2 through 1001
E. 2 through 4094
Which Cisco technology provides network redundancy by combining two physically separate
switches to a single logical switch’?
Which two commands configure RSPAN to capture incoming and outgoing traffic on a single
interface’? (Choose two)
A. monitor session 1 source interface gigabitethernetl/0/2 tx
B. monitor session 1 destination remote vlan 910
C. monitor session 1 source interface gigabitethernetl/0/1 rx
D. monitor session 1 destination interface gigabitethernetl/0/2 rx
E. monitor session 1 source interface gigabitethernet1/0/2 both
Which feature is enabled automatically when you configure HSRP on an interface?
A. ICMP redirect messages
B. HSRP tracking
C. IGMP snooping
D. HSRP preemption
Which command do you enter to troubleshoot a misconfigured EtherChannel?
A. CORE-SW(config)#spanning-tree etherchannel guard misconfig.
B. CORE-SW(config-if)#spanning-tree guard root
C. CORE-SW(config-if)#spanning-tree loopguard default
D. CORE-SW(config-if)#spanning-tree etherchannel guard misconfig
Which statement about configuring an RSPAN session is true?
A. RSPAN supports, by default, the monitoring of Layer 2 switch protocols.
B. The same RSPAN VLAN is used for a RSPAN session on all the switches.
C. Only the source switch in a session must support RSPAN
D. At least one access port must be configured in the RSPAN VLAN
New Updated 300-115 Exam Questions 300-115 PDF dumps 300-115 practice exam dumps:https://www.dumpsschool.com/300-115-exam-dumps.html